Overview
The Starlink Mini is a great fit for a 310RL: it's small, has a built-in Wi-Fi router, and runs on DC power. Starlink lists an average draw of 20–40 W (about 15 W idle) and a 12–48 V DC, 60 W input.
Our experience: I'm a software engineer who works remotely, and the Mini has been a game changer. Speed and reliability have held up through full workdays on the road. The night we arrived at a park after dark, I had to hang it temporarily in a tree branch full of leaves, and we still had a usable signal.
Where to put it
- On the included kickstand at a clear spot near the rig
- On a pole or the rear ladder
- Permanently on the roof
We started with an inexpensive aluminum clamp mount on the rear ladder. It held the Mini well, but every setup and teardown meant climbing the ladder. We upgraded to a 10 ft adjustable pole mount that clamps to the ladder rails. Now the dish sits above the roofline and nearby trees, and we raise and lower it from the ground.

Getting the cable inside
We run the Starlink cable down the ladder and keep it from flapping in the wind with reusable silicone twist ties. From the bottom of the ladder it goes under the rig, up through the hose pass-through into the basement, and into the 110V outlet next to the water panel. No new holes needed.
If you'd rather bring the cable in through the roof or a wall, use a weatherproof cable gland and self-leveling sealant. One 2021 owner planned to run it down the roof-access opening above the water heater.
Power
Today we use the stock Starlink power supply plugged into that basement outlet, running from shore power or the inverter.
Next we're moving it to 12V: a weatherproof Starlink Mini pass-through socket with a built-in 12V-to-30V booster mounted in the rear skirt, fed by a fused 12V run along the frame to the bus bar in the front electrical compartment. That skips the inverter entirely and lets us plug the Mini in outside. We'll update this guide once it's installed.
If you'd rather power it over USB-C, Starlink requires a 100 W (20V/5A) USB-C PD source and its USB-C to barrel jack cable. The Mini won't run on USB-C PD sources below 65 W.
Buying a Starlink Mini
Buy it direct from Starlink. Most Starlink Mini listings we found on Amazon are third-party resellers, not Starlink. The Starlink button under What You’ll Need below is our referral link: if you order through it, we may receive a referral credit at no extra cost to you.





