KnowMyRig
How-To

2026 Alliance Paradigm 310RL Complete Winterization Guide

Michael Pardon

2026 Alliance Paradigm 310RL Complete Winterization Guide

Step-by-step winterizing procedure for the 2026 Alliance Paradigm 310RL fifth wheel, covering tank draining, water heater bypass, whole-house filter removal, optional compressed air blowout, and pumping RV antifreeze via the docking station winterization suction port and water manifold system.

Applies to: 2026 Alliance RV Paradigm 310RL, 12-Gallon Gas/Electric Water Heater, Dometic 310 Series Gravity Flush Toilet

Steps:

  1. Preparation & Draining Tanks:
    • Empty and flush the black and gray holding tanks completely at a dump station
    • Open the fresh water tank drain valve to empty the fresh tank.
    • Turn OFF both electric and gas water heater switches. Relieve system pressure by opening a hot water faucet inside, then remove the water heater drain plug/anode rod (using a 1-1/16" socket) or open the drain valve to empty the water heater.
  2. Water Heater Bypass & Low-Point Drains:
    • Access the plumbing bay/behind the access panel and turn the water heater bypass valve(s) to the BYPASS position so antifreeze does not fill the water heater.

    • Locate the Alliance Water Manifold system and open the hot and cold low-point drain valves at the bottom of the manifold/docking station to drain residual water from the lines.
  3. Whole-House Water Filter Removal:
    • Unscrew the whole-house water filter canister housing using a filter wrench.
    • Remove and discard the filter cartridge, empty the canister, and screw the empty canister housing back on snugly (or install a filter bypass if equipped).
  4. Compressed Air Blowout (Optional but Recommended):
    • Thread a blowout plug into the City Water Inlet at the docking station and set the City/Tank fill switch to the City Water position.
    • Connect an air compressor regulated to a MAXIMUM of 30–40 PSI.
    • Open one fixture at a time (hot and cold on kitchen sink, bathroom vanity, shower, toilet flush, and exterior utility spray port) until only air comes out. Close all drains and faucets when finished.
  5. Pump RV Antifreeze Through the Plumbing System
    • Close the hot and cold low-point drain valves on the ManiFlo manifold.
    • Verify the water heater has been drained and placed in "bypass" mode.
    • Connect a short siphon hose to the "City Water" inlet in the wet bay.
    • Place the other end of the hose into a jug of non-toxic RV/Marine antifreeze.
    • Turn on the 12V water pump. The pump will draw antifreeze from the container through the City Water Inlet and into the RV’s plumbing system.
    • Watch the antifreeze level and change jugs as necessary so the hose does not draw air.
    • Once the pump has pressurized the system, proceed to each fixture and run the hot and cold sides until solid pink antifreeze appears.
    • [Visual Aid Tip: Insert photo of the docking station showing the City/Tank fill switch, winterization valve position, and siphon hose submerged in the RV antifreeze jug]
  6. Pumping Antifreeze Through All Fixtures:
    • Starting from the closest fixture or working systematically, open the cold side and then the hot side at the kitchen sink, bathroom lavatory sink, and interior shower until a steady stream of solid pink RV antifreeze flows out.
    • Hold down the toilet foot pedal until solid pink antifreeze flushes into the bowl.
    • Connect the exterior coil hose to the outside utility spray port and run both hot and cold until pink appears.
  7. Residential Refrigerator Ice Maker:
    • If using the compressed air method or antifreeze method on the residential fridge water line: ensure the dedicated ice maker shut-off valve on the water manifold is open, cycle the water dispenser/ice maker cycle or disconnect the inlet line behind the fridge to purge water until pink antifreeze appears, then turn the ice maker OFF.
  8. Washer Prep:
    • Run brief hot and cold cycles or disconnect caps on the washer prep connections in the front closet to clear standing water in the valves.
  9. P-Traps, Toilet Seal & Black Tank Check Valve:
    • Turn OFF the 12V water pump and open a faucet briefly to release line pressure.
    • Pour 1 to 2 cups of RV antifreeze down every drain (kitchen sink, bathroom sink, and shower drain) to protect the P-traps from freezing.
    • Leave a small pool of antifreeze in the toilet bowl over the blade seal to keep the gasket pliable.
    • Briefly pump or blow air/antifreeze into the Black Tank Flush inlet at the docking station to protect the vacuum breaker/check valve from freeze damage.

Official Video & Manual Resources:

- Official Alliance RV Video Tutorial: Owner Empowerment Series: Winterizing Your Paradigm RV


- Quick Tip on Winterizing Your Alliance RV


- 2026 Alliance RV Paradigm Owner's Manual PDF

1 found helpful · 0 not helpful

Did this help? Pass it on.

Share it with your network or save it for reference later.

Still stuck? Ask about this guide